Sign my
GuestBook

NS class 5000

Detailing the superstructure

Usually I make a page about detailing, painting and final assembly consecutively. But as this project is about detailing an existing model all is a bit different. I will follow that order not in pages but per subject

Windows

 

First let's start with the parts that cme form the Dido Model Railways detailing kit.

Top a folded window. Bottom as straight out of the etch.

The back sheet and tender door were supplied as one part (right hand side). The instructions warned that the door could hamper layout operation in tight curves, so I decided to add a hinge and make the door moveable (left). The hinges on the door are made from 0.2 mm brass strip.
The hinge pin is soldered from 0.5 mm nickel silver wire.
To fold the hinges around the pin the door is put in the vise, the bak sheet is placed over it and the hinges are bent over the pin ....
... the door is taken out of the vise and lied flat the hinges are fully folded over.
and soldered with 140C solder.
The fall plate is bent just a little over its width. Fall plates almost always have a gentle curve.

I did a lot of thinking how to make the fall plate hinge, more or less analogous to the hinges for the tender doors,without making the hinge too difficult hinge or too high. When I sat back, more or less at a loss how to solve this, I remembered recently having thrown away some polyethene plastic. I retrieved it from the bin and cut out a piece of the the bottom end which was nicely folded. If I glue that with epoxy to the fall plate and to the cab bottom respectively I have the hinge I want.

 

One of the changes made to the class was removal of the vaccum brake.So I took off the ejector exhaust pipe.

The coupler hook was removed and the European link coupler was installed, here temporarily. I damaged the paint whil opening up the square hole so I need to spray it.

 

On the tender the coupler space was removed and installed upside down so it won't get lost

Coupler installed on the tender and two plastic air hoses. The hoses are a bit oversize, but the model is in OO anyway so it won't be too conspicuous.

 

A stack elongation was made from two styrene tubes, a strip of styrene and some work.

 

A rack for the fireman's tools.